Tubing Inflatable sled NT Multi-colored Strykoza 120 cm (0911)

Tubing. Inflatable sled 120 cm

Tubing. Inflatable sleds, tubes, cheesecakes, 120 cm

Inflatable sleds - also known as tubes, cheesecakes, tubes - are a new, modern multifunctional replacement for the classic metal-wooden sleds. This type of entertainment can be found at any ski resort. By giving such a thing to your child, you will give him an excellent incentive for an active and useful winter holiday, instead of sitting at the computer.

Camera included!!!

Cheesecake sleds are absolutely safe, especially in comparison with ordinary sleds, since they do not have sharp corners or protruding parts that can cut skin or damage clothing. They are also lightweight and will not cause harm if they fall on a child.

Ease of transportation is one of the advantages of this product; when deflated, the tubing is compact.

Construction. The tubing washer is a rubber chamber, in a special casing made of high-strength PVC and Oxford fabrics. These fabrics withstand friction and are wear-resistant. All sled materials pass the “cold test” perfectly and can be used at temperatures down to -30 degrees Celsius. Even with extreme use, the tubes will last quite a long time.

As you can see, only advantages! This gift will appeal not only to children, but also to adults.

Characteristics:

Manufacturer: Ukraine

Inflatable sled Puck for downhill skating.

Diameter 120 centimeters (inflated).

Advantages of the product:

· ease of transportation

· absolutely safe

· fabrics withstand friction, wear-resistant

Characteristics:

Manufacturer: Ukraine

Material: Oxford 600D, PVC 650

Diameter 120 cm (inflated form)

Advantages of the product:

· ease of transportation

· absolutely safe < /p>

· fabrics withstand friction and are wear-resistant

Equipment:

• tubing case
• camera R16 < /li>
• Spool
• cap

How to inflate a tube?

Step-by-step instructions

• Step 1. Take out the tube and lay it out so that it is convenient for you to work with it.
• Step 2. Place the camera evenly and centrally into the tubing case through the central hole. Pull the tow rope through the camera so that it wraps around the camera and goes out through a special hole.
• Step 3. Connect the pump and start pumping. During the inflation process, make sure that the camera is approximately in the center of the sled cover, adjust if necessary. Pump until the chamber fills the entire internal volume of the tube. Stop pumping when the Tubing reaches its size.
• Step 4: Disconnect the pump and close the protective cap.
• Step 5 Zip it up
• Done!